46 Results
View results:
Sort by:
Add-ons for Timber Structures
Which Dlubal software products do you recommend for the structural analysis and design of timber structures in particular?
Advantages of CFD Simulation
What are the advantages of CFD simulation compared to conventional experimental tests?
Add-ons for Concrete Structures
Which products do you recommend for the structural analysis and design of reinforced concrete structures?
RWIND Calculation Error E315
When performing high-quality transient simulations with a high number of mesh cells, I get this error: "Calculation failed! RWindSolverTransient failed, E315." After that, RWIND stops without results. What can I do?
Power Plants and Conveyor Structures
Which programs can I use to design power plants and conveyor structures?
How can I connect surfaces to other surfaces or members in a hinged/semi-rigid way in RFEM 6?
How can I connect surfaces to other surfaces or members in a hinged/semi-rigid way?
What are Line Hinges and Line Releases?
Hardware and System Requirements
What are the minimum requirements for RFEM 6 and RSTAB 9?
Welds in RFEM 6
In the case of stairs with a complicated geometry, it is often difficult to design welds by using the analytical methods. How can I do this with RFEM?
Weekly Release of New Versions
Why does Dlubal Software release new versions of RFEM 6, RSTAB 9, and RSECTION every week?
Load on Non Coplanar Structures
How do I apply load on members that are non coplanar in RFEM 6?
Wind Load on Open Structures
How do I apply wind load on members of open structures in RFEM 5?
Question
I want to create a mapped mesh for a circular hole plate. Is it possible to generate such a mesh in RFEM?
Question
How can I optimize the calculation time in CRANEWAY?
Question
How do I create a frame joint with taper in JOINTS Steel - Rigid?
Question
How can I create a drilled beam in RFEM?
Question
How can I additionally model welds for the connection of two surfaces with a contact solid?
Question
In connection with a calculation according to the large deformation analysis, I get significantly smaller deformations than for a calculation according to the linear static or second-order analysis. How is this possible?
Question
I get a message saying that the General Method is only allowed for I-sections, even though I do want to design an I-section. Why?
Question
I have calculated a box girder. Which surface results or surface stresses can I use to evaluate the buckling behavior of the web plates?
Question
When entering data in the RF‑/STEEL EC3 add-on module, I get the error message "Incorrect location of the intermediate lateral restraint". Why?
Question
When creating a material, there are no nonlinear material models available for surfaces or solids. Why?
Desing in Industrial and Plant Engineering
Are Dlubal Software programs applicable for the analysis of process manufacturing plants?
Question
How can I deduce the axial stress and hoop stress of a circular container?
Question
How can I connect surfaces to other surfaces or members in a hinged/semi-rigid way?
Design of Piping Systems
Is it possible to analyze and design piping systems with Dlubal Software?
- 004165
- RFEM 5
- RSTAB 8
-
- Power Plants
- Steel Structures
- Process Manufacturing Plants
- Bridges
- Towers and Masts
- Temporary Structures
- Scaffolding and Rack Structures
- Offshore Structures
- Silos and Storage Tanks
- Buildings
- Piping Systems
- Cranes and Craneways
- Renewable Energy Structures
- Conveyor Structures
- Drilling Structures
- Stairway Structures
- Wind Simulation & Wind Load Generation